Dell PowerEdge FX2/FX2s - Manual (Page 185)

15
Isolated Networks
This chapter describes the isolated networks commands in the Dell Networking OS.
io-aggregator isolated-network vlan
Enable the isolated-network functionality for a particular VLAN or a set of VLANs.
Syntax [no] io-aggregator isolated-network vlan vlan-range
Parameters
isolated-
network Specify an isolated network to be configured
vlan vlan-
range Enter the keyword vlan followed by the member VLANs
using VLAN IDs (separated by commas), a range of VLAN IDs
(separated by a hyphen), a single VLAN ID, or a combination.
For example: VLAN IDs (comma-separated): 3, 4, 6. Range
(hyphen-separated): 5-10. Combination: 3, 4, 5-10, 8.
Defaults Not configured.
Command
Modes CONFIGURATION
Usage
Information To add more VLANs into an isolated network, you can enter this same command at
any later point. The VLANs specified are appended to the existing set of VLANs. To
remove a VLAN or a set of VLANs from an isolated network, use the no form of
command.
Command
History
Version 9.5(0.0) Supported on the FN I/O aggregator.
Example
Dell(conf)#io-aggregator isolated-network vlan 5-10
show io-aggregator isolated-networks
Display the VLANs that are configured to be part of an isolated network on an Aggregator.
Syntax show io-aggregator isolated-networks
185