Dell PowerEdge FX2/FX2s - Manual (Page 380)

Defaults 4 x hello
Command
Modes CONFIGURATION (conf-lldp) and INTERFACE (conf-if-interface-lldp)
Command
History
Version 9.4(0.0) Supported on the FN I/O aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
NPIV Proxy Gateway
The N-port identifier virtualization (NPIV) Proxy Gateway (NPG) feature provides FCoE-FC bridging
capability on the FN 2210S Aggregator, allowing server CNAs to communicate with SAN fabrics over the
FN 2210S Aggregator.
To configure the FN 2210S I/O Aggregator to operate as an NPIV proxy gateway, use the following
commands:
dcb-map
Create a DCB map to configure priority flow control (PFC) and enhanced transmission selection (ETS) on
Ethernet ports that support converged Ethernet traffic. Apply the DCB map to an Ethernet interface.
I/O Aggregator
Syntax dcb-map map-name
Parameters
map-name Enter a DCB map name. The maximum number of
alphanumeric characters is 32.
Defaults None. There are no pre-configured PFC and ETS settings on S5000 Ethernet
interfaces.
Command
Modes CONFIGURATION
INTERFACE
Command
History
Version 9.4(0.0) Supported on the FN I/O aggregator.
Usage
Information
A DCB map is a template used to configure DCB parameters and apply them on
converged Ethernet interfaces. DCB parameters include priority-based flow control
(PFC) and enhanced traffic selection (ETS).
To display the PFC and ETS settings in DCB maps, enter the show qos dcb-map
command.
Use the dcb-map command to create a DCB map to specify PFC and ETS settings
and apply it on Ethernet ports. After you apply a DCB map to an interface, the PFC
and ETS settings in the map are applied when the Ethernet port is enabled. DCBx is
enabled on Ethernet ports by default.
380