Dell PowerEdge FX2/FX2s - Manual (Page 250)

This command is used to reset the stack-unit. The master unit can also be power
cycled using this command.
reset stack-unit
Reset any designated stack member except the management unit (master unit).
Syntax reset stack-unit 0–5 hard
Parameters
0–5 Enter the stack member unit identifier of the stack member
to reset.
hard Reset the stack unit if the unit is in a problem state.
Defaults none
Command
Modes EXEC Privilege
Command
History
Version 9.6.
(0.0) Supported on the FN I/O Aggregator.
Usage
Information
This command is supported on the FN410S and the FN410T Aggregators
Resetting the management unit is not allowed and an error message displays if you
try to do so. Resetting is a soft reboot, including flushing the forwarding tables.
You can run this command directly on the stack standby unit (Standby Master) to
reset the standby. You cannot reset any other unit from the standby unit
Example
Dell#show system brief
Stack MAC : 00:1e:c9:f1:00:9b
-- Stack Info --
Unit UnitType Status ReqTyp CurTyp
Version Ports
---------------------------------------------------------------
------------------
---
0 Management online I/O-Aggregator I/O-
Aggregator 8-3-17-46 56
1 Standby online I/O-Aggregator I/O-
Aggregator 8-3-17-46 56
2 Member not present
3 Member not present
4 Member not present
5 Member not present
Dell#
Dell#reset stack-unit 0 >>>Resetting master not allowed
% Error: Reset of master unit is not allowed.
Dell#
Dell#reset stack-unit 1
Dell#01:02:00: %STKUNIT0-M:CP %CHMGR-5-STACKUNIT_RESET: Stack
unit 1 being reset
250