Dell PowerEdge FX2/FX2s - Manual (Page 321)

Command
History
Version 9.4(0.0) Supported on the FN I/O aggregator.
ip address dhcp
Acquire an IP address dynamically on an interface from the DHCP server.
Syntax ip address dhcp [relay | vendor-class-identifier]
To disable DHCP Client on an interface, use the no ip address dhcp command.
Command
Modes INTERFACE
Default Enabled
Command
History
Version 9.4(0.0) Supported on the FN I/O aggregator.
Usage
Information
In the I/O Aggregator, the DHCP client is enabled only on the default VLAN and
management interface 0/0. Use the ip address command to assign a static IP
address that overwrites the dynamically assigned IP address.
show ip dhcp client statistics
Displays DHCP client statistics, including the number of DHCP messages sent and received on an
interface.
Syntax show ip dhcp client statistics interface type slot/port
Parameters
interface type
slot/port Display DHCP client statistics on the specified interface.
• For the management interface on the stack-unit, enter
the keyword managementethernet followed by slot/
port information. The slot and port range is 0.
• For a VLAN, enter the keyword vlan followed by a
number from 1 to 4094.
Command
Modes EXEC Privilege
Default None.
Command
History
Version 9.4(0.0) Supported on the FN I/O aggregator.
show ip dhcp lease
Displays lease information about the dynamic IP address currently assigned to a DHCP client-enabled
interface.
Syntax show ip dhcp lease[interface type slot/port]
321