Dell PowerEdge FX2/FX2s - Manual (Page 395)

Usage
Information
The dot1p-priority command changes the priority of incoming traffic on the
interface. The system places traffic marked with a priority in the correct queue and
processes that traffic according to its queue.
When you set the priority for a port channel, the physical interfaces assigned to the
port channel are configured with the same value. You cannot assign the dot1p-
priority command to individual interfaces in a port channel.
service-class dynamic dot1p
Honor all 802.1p markings on incoming switched traffic on an interface (from INTERFACE mode) or on all
interfaces (from CONFIGURATION mode). A CONFIGURATION mode entry supersedes an INTERFACE
mode entry.
Syntax service-class dynamic dot1p
To return to the default setting, use the no service-class dynamic dot1p
command.
Defaults All dot1p traffic is mapped to Queue 0 unless you enable the service-class
dynamic dot1p command. The default mapping is as follows:
dot1p Queue ID
0 0
1 0
2 0
3 1
4 2
5 3
6 3
7 3
Command
Modes
• INTERFACE
• CONFIGURATION
Command
History
Version 9.4(0.0) Supported on the FN I/O aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Usage
Information
To honor all incoming 802.1p markings on incoming switched traffic on the
interface, enter this command. By default, this facility is not enabled (that is, the
802.1p markings on incoming traffic are not honored).
You can apply this command on both physical interfaces and port channels. When
you set the service-class dynamic for a port channel, the physical interfaces
395