Stacking commands, Power-cycle stack-unit, 24 stacking commands – Dell PowerEdge FX2/FX2s User Manual
Page 249
24
Stacking Commands
Stacking is supported on the FN410S and FN410T cards with ports 9 and 10 as the stack ports. Stacking is
limited to six Aggregators in the same or different chassis in a single stack.
Stacking provides a single point of management and NIC teaming for high availability and higher
throughput. To configure an Aggregator stack, you must use the CLI.
The stacking commands are always available and operational. You can use the commands to pre-
configure an Aggregator, so that the configuration settings are invoked when the Aggregator is attached
to other Aggregator blades.
For more information about using the Aggregator stacking feature, refer to the Stacking Aggregators
chapter in the Dell Networking OS Configuration Guide for the FN I/O Aggregator.
You can use the following commands to manage a stack of Aggregator I/O modules:
•
•
•
•
show system stack-unit stack-group
•
power-cycle stack-unit
To hard reset any stack unit including master unit.
Syntax
power-cycle stack-unit unit-number
Parameter
Unit number
The unit number ranges from 0 to 5.
Defaults
None
Command
Modes
EXEC Privilege
Command
History
Version 9.6.
(0.0)
Supported on the FN I/O Aggregator.
Usage
Information
This command is supported on the FN410S and the FN410T Aggregators.
249