Dell PowerEdge FX2/FX2s - Manual (Page 207)

20
Quality of Service (QoS)
The Dell Networking OS commands for quality of service (QoS) include traffic conditioning and
congestion control.
This chapter contains the following section:
• Policy-Based QoS Commands
Policy-Based QoS Commands
Policy-based QoS is not supported on logical interfaces, such as port-channels, VLANs, or Loopbacks.
The commands are:
• show qos dcb-map
• show qos dot1p-queue-mapping
show qos dcb-map
Display the DCB parameters configured in a specified DCB map.
Syntax show qos dcb-map map-name
Parameters
map-name Displays the PFC and ETS parameters configured in the
specified map.
Command
Modes
• EXEC
• EXEC Privilege
Command
History
Version 9.4(0.0) Supported on the FN I/O aggregator.
Usage
Information
Use the show qos dcb-map command to display the enhanced transmission
selection (ETS) and priority-based flow control (PFC) parameters used to configure
server-facing Ethernet ports.
The following table describes the show qos dcb-map output shown in the
example below.
207