Dell PowerEdge FX2/FX2s - Manual (Page 356)

• auto-negotiation enabled speed 100
• auto-negotiation disabled speed 100
• auto-negotiation disabled speed 100
• auto-negotiation enabled* speed 1000 or auto
Port 1
• auto-negotiation enabled* speed 1000 or auto
• auto-negotiation enabled speed 100
• auto-negotiation disabled speed 100
• auto-negotiation enabled speed 100
• auto-negotiation disabled speed 100
Link Status Between Port 1 and Port 2
• Up at 1000 Mb/s
• Up at 100 Mb/s
• Up at 100 Mb/s
• Down
• Down
* You cannot disable auto-negotiation when the speed is set to 1000 or auto.
portmode hybrid
To accept both tagged and untagged frames, set a physical port or port-channel. A port configured this
way is identified as a hybrid port in report displays.
Syntax portmode hybrid
To return a port to accept either tagged or untagged frames (non-hybrid), use the
no portmode hybrid command.
Defaults non-hybrid
Command
Modes INTERFACE (conf-if-interface-slot/port)
Command
History
Version 9.4(0.0) Supported on the FN I/O aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Usage
Information
The following describes the interface command shown in the following
example. This example sets a port as hybrid, makes the port a tagged member of
VLAN 20, and an untagged member of VLAN 10, which becomes the native VLAN
of the port. The port now accepts:
• untagged frames and classify them as VLAN 10 frames
• VLAN 20 tagged frames
356