Dell PowerEdge FX2/FX2s - Manual (Page 379)

disable
Enable or disable LLDP.
Syntax disable
To enable LLDP, use the no disable command.
Defaults Enabled, that is no disable.
Command
Modes CONFIGURATION (conf-lldp) and INTERFACE (conf-if-interface-lldp)
Command
History
Version 9.4(0.0) Supported on the FN I/O aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Related
Commands
debug lldp interface — debugs LLDP.
hello
Configure the rate at which the LLDP control packets are sent to its peer.
Syntax hello seconds
To revert to the default, use the no hello seconds command.
Parameters
seconds Enter the rate, in seconds, at which the control packets are
sent to its peer. The rate is from 5 to 180 seconds. The
default is 30 seconds.
Defaults 30 seconds
Command
Modes CONFIGURATION (conf-lldp) and INTERFACE (conf-if-interface-lldp)
Command
History
Version 9.4(0.0) Supported on the FN I/O aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
multiplier
Set the number of consecutive misses before LLDP declares the interface dead.
Syntax multiplier integer
To return to the default, use the no multiplier integer command.
Parameters
integer Enter the number of consecutive misses before the LLDP
declares the interface dead. The range is from 2 to 10.
379