Pmux mode of the i/o aggregator, Data center bridging (dcb), Advertise dcbx-appln-tlv – Dell PowerEdge FX2/FX2s User Manual
Page 295: 30 pmux mode of the i/o aggregator, Pmux mode of the io aggregator
30
PMUX Mode of the I/O Aggregator
This chapter describes the various CLI commands applicable in PMUX mode.
Data Center Bridging (DCB)
Data center bridging (DCB) refers to a set of IEEE Ethernet enhancements that provide data centers with a
single, robust, converged network to support multiple traffic types, including local area network (LAN),
server, and storage traffic.
The Dell Networking Operating System (OS) commands for data center bridging features include
802.1Qbb priority-based flow control (PFC), 802.1Qaz enhanced transmission selection (ETS), and the
data center bridging exchange (DCBX) protocol.
advertise dcbx-appln-tlv
On a DCBX port with a manual role, configure the application priority TLVs advertised on the interface to
DCBX peers.
Syntax
advertise dcbx-appln-tlv {fcoe | iscsi}
To remove the application priority TLVs, use the no advertise dcbx-appln-
tlv {fcoe | iscsi} command.
Parameters
{fcoe | iscsi}
Enter the application priority TLVs, where:
• fcoe: enables the advertisement of FCoE in application
priority TLVs.
• iscsi: enables the advertisement of iSCSI in application
priority TLVs.
Defaults
Application priority TLVs are enabled to advertise FCoE and iSCSI.
Command
Modes
PROTOCOL LLDP
Command
History
Version 9.4(0.0)
Supported on the FN I/O aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Usage
Information
To disable TLV transmission, use the no form of the command; for example, no
advertise dcbx-appln-tlv iscsi.
295