Dell PowerEdge FX2/FX2s - Manual (Page 81)

ssh-peer-stack-unit
Open an SSH connection to the peer stack-unit.
Syntax ssh-peer-stack-unit [-| username]
Parameters
-| username (OPTIONAL) Enter the keyword -| followed by your
username.
Default: The username associated with the terminal.
Defaults Not configured.
Command
Modes
• EXEC Privilege
Command
History
Version 9.6.
(0.0) Supported on the FN I/O Aggregator.
Version 8.3.17.0 Supported on the M I/O Aggregator.
telnet
Connect through Telnet to a server. The Telnet client and server in Dell Networking OS support IPv4 and
IPv6 connections. You can establish a Telnet session directly to the router or a connection can be
initiated from the router.
Syntax telnet {host | ip-address [/source-interface]
Parameters
host Enter the name of a server.
ip-address Enter the IPv4 address in dotted decimal format or the IPv6
address in the x:x:x:x::x format of the server.
NOTE: The :: notation specifies successive hexadecimal
fields of zeros. Only one occurrence of this notation is
permitted in an IPv6 address.
source-
interface (OPTIONAL) Enter the keywords /source-interface then
the interface information to include the source interface.
Enter the following keywords and slot/port or number
information:
• For a 10-Gigabit Ethernet interface, enter the keyword
TenGigabitEthernet then the slot/port information.
• For a VLAN interface, enter the keyword vlan then a
number from 1 to 4094.
81