Dell PowerEdge FX2/FX2s - Manual (Page 398)

Defaults none
Command
Modes CONFIGURATION (conf-qos-policy-out)
Command
History
Version 9.4(0.0) Supported on the FN I/O aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Usage
Information
The unit of bandwidth percentage is 1%. A bandwidth percentage of 0 is allowed
and disables the scheduling of that class. If the sum of the bandwidth percentages
given to all eight classes exceeds 100%, the bandwidth percentage automatically
scales down to 100%.
Related
Commands qos-policy-output — creates a QoS output policy.
description
Add a description to the selected policy map or QoS policy.
Syntax description {description}
To remove the description, use the no description {description}
command.
Parameters
description Enter a description to identify the policies (80 characters
maximum).
Defaults none
Command
Modes CONFIGURATION (policy-map-input and policy-map-output; conf-qos-policy-in
and conf-qos-policy-out; wred)
Command
History
Version 9.4(0.0) Supported on the FN I/O aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Related
Commands
policy-map-output — creates an output policy map.
qos-policy-output — creates an output QoS-policy on the router.
policy-aggregate
Allow an aggregate method of configuring per-port QoS via policy maps. An aggregate QoS policy is part
of the policy map (input/output) applied on an interface.
Syntax policy-aggregate qos-policy-name
To remove a policy aggregate configuration, use the no policy-aggregate
qos-policy-name command.
398