Dell PowerEdge FX2/FX2s - Manual (Page 351)

interface vlan — configures a VLAN interface.
interface vlan
Configure a VLAN. You can configure up to 4094 VLANs.
Syntax interface vlan vlan-id
To delete a VLAN, use the no interface vlan vlan-id command.
Parameters
vlan-id Enter a number as the VLAN Identifier. The range is from 1 to
4096.
Defaults Not configured, except for the Default VLAN, which is configured as VLAN 1.
Command
Modes CONFIGURATION
Command
History
Version 9.4(0.0) Supported on the FN I/O aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
Usage
Information
For more information about VLANs and the commands to configure them, refer to
the Virtual LAN (VLAN) Commands.
FTP, TFTP, and SNMP operations are not supported on a VLAN. MAC/IP ACLs are
not supported.
Example
Dell(conf)#int vlan 3
Dell(conf-if-vl-3)#
Related
Commands
interface — configures a physical interface.
interface port-channel — configures a port channel group.
intf-type cr4 autoneg
Set the interface type as CR4 with auto-negotiation enabled.
Syntax intf-type cr4 autoneg
If you configure intf-type cr4 autoneg, use the no intf-type cr4
autoneg command to set the interface type as cr4 with autonegotiation disabled.
Defaults Not configured
Command
Modes CONFIGURATION
Command
History
Version 9.4(0.0) Supported on the FN I/O aggregator. This command is
supported in Programmable-Mux (PMUX) mode only.
351