Checkline TI-MINIMAX - Manual (Page 126)

Dakota Ultrasonics
120
The following is a list of the viewable features on the display:
A) Stability of Reading Indicator – Indicates the stability of the return echo on
a scale of 1 to 6 – the solid bars displayed in the figure above indicate a
repeatable signal. If the MINI-MAX is displaying a reading from memory, the
repeatability indicator will be replaced by the text
“MEM”.
B) Battery life indicator – Fully charged batteries will appear filled in solid.
Note: The diagram shows the batteries at approximately 50%.
C) Quantity – Displays the current measurement quantity (currently Elongation).
D) Limits Bar – The limits bar is used to verify if the bolt being fastened is in
inside of a specific set of tolerances. The alarm or tolerance values are
shown at (F). When the bolt is in tolerance, the limit bar will be filled and
inside the corresponding limits.
E) Units Label - Displays the current quantity of measurement.
F) Alarm (Tolerance) Values – Displays the minimum and maximum alarm
values or tolerances.
G) Length Measurement – Digital readout of quantity (English or metric).
H) Hot Menus - Each of the fields located under the waveform display are called
the
Hot Menu Fields. These fields allow quick control of some of the fine
adjustments needed to control the display settings, measurement modes, and
group memory control. All of these fields can be adjusted without having to
activate the tabbed menu items and searching through a variety of menus to
make adjustments.
I) Temperature – Display’s the current temperature of the fastener (manual,
semi-automatic, or automatic).
12.3 Adjusting the Display
The width refers to the overall viewable range, with respect to length, being
displayed on the screen. The starting length is displayed at the lower left side of
the screen, and the ending length is shown at the lower right hand side of the
screen. The difference between these values is called the
Width. The
procedures to adjust the Width are outlined below: