Checkline TI-MINIMAX - Manual (Page 31)

MINI-MAX Ultrasonic Bolt Tension Monitor
4.8 SETUP – Menu
Open: Displays a list of factory and user defined setups currently stored in
memory. These setups can be recalled and used at any time. The setup
contains all the information about a specific bolting application. Refer to section
15.1 for further info.
Save: Provides the user with the ability to save a custom bolting application
setup that has been modified or created by the user. Refer to section 15.3 for
further info.
Default Setup: Loads a basic default setup. Use only as a last resort when the
setups in the MINI-MAX have been corrupted and a computer is not accessible
to restore previously save setups. Refer to section 15.4 for further info.
4.9 DATA – Menu
New: Allows the user the ability to create a new group with a specified number
of bolts and measurements per bolt. A group can contain 250 bolts, 1 reference
length, and 51 measurements per bolt, depending on the application
requirements. Refer to section 14.2 for further info.
Edit: Gives the user the ability to change the note and increment direction of a
previously save group. Refer to section 14.6 for further info.
Open: This function provides the user with the ability to recall a group that
currently exists in memory from a list of groups. Refer to section 14.7 for further
info.
Delete One Group: This function provides the user with the ability to delete a
single group from a list of multiple groups previously saved in memory. Refer to
section 14.5 for further info.