Checkline TI-MINIMAX - Manual (Page 72)

Dakota Ultrasonics
66
Selecting the Number of Readings Per Bolt
Note: A bolt can have up to 51 possible measurements and 1 unloaded
reference length (L-REF). There must be at least one reading per bolt.
Since the group is being created to store probe Zero Data and verify
linearity on a periodic basis prior to measuring or starting a new application,
consider selecting all 51 readings.
1) Use the UP and DOWN arrow keys to scroll through the new Group
List Items until NUM READS is highlighted.
2) Press the ENTER key to display the Digits Edit Box.
3) Press the UP and DOWN arrow keys to scroll the highlighted value.
4) Press the LEFT and RIGHT arrow keys to scroll the digit locations.
5) Repeat steps 3 & 4 until the NUM READS value is correctly displayed.
6) Press the OK key to save the NUM READS and return to the Group
List Items menu, or ESC to cancel entering the NUM READS.
Note: If a number less than 1 or greater than 50 is entered, an error
message box “VALUE IS OUT OF RANGE” will be displayed.