Interlogix NS3500-28T-4S User Manual - Manual (Page 20)

20
The console port is a RJ-45 port connector. It is an interface for connecting a terminal directly. Through the console
port, it provides rich diagnostic information including IP Address setting, factory reset, port management, link status
and system setting. Users can use the attached DB9 to RJ-45 console cable in the package and connect to the
console port on the device. After the connection, users can run any terminal emulation program (Hyper Terminal,
ProComm Plus, Telex, Winterm and so on) to enter the startup screen of the device.
■ Reset Button
At the left of front panel, the reset button is designed for reboot the Managed Switch without turn off and on the
power. The following is the summary table of Reset button functions :
Reset Button Pressed and Released Function
< 5 sec : System Reboot Reboot the Managed Switch.
> 5 sec : Factory Default
Reset the Managed Switch to Factory Default configuration.
The Managed Switch will then reboot and load the default
settings as below:
。 Default Username: admin
。 Default Password: admin
。 Default IP address: 192.168.0.100
。 Subnet mask: 255.255.255.0
。 Default Gateway: 192.168.0.254
2.1.2 LED Indications
The front panel LEDs indicates instant status of port links, data activity and system power; helps monitor and
troubleshoot when needed. Figure 2-1-2 shows the LED indications of these Managed Switches.
LED Indication



Figure 2-1-2 NS3500-28T-4S LED panel