Interlogix NS3500-28T-4S User Manual - Manual (Page 77)

77

Port Select Select port number for this drop down list.
 Enabled Indicates the port state operation. Possible state are:
Enabled - Start up the port manually.
Disabled – Shut down the port manually.
 Speed Select any available link speed for the given switch port. Draw the menu bar to
select the mode.
 Auto - Setup Auto negotiation.
 Auto-10M - Setup 10M Auto negotiation.
 Auto-100M - Setup 100M Auto negotiation.
 Auto-1000M - Setup 1000M Auto negotiation.
 Auto-10/100M - Setup 10/100M Auto negotiation.
 10M - Setup 10M Force mode.
 100M - Setup 100M Force mode.
 1000M - Setup 1000M Force mode.

Duplex
Select any available link duplex for the given switch port. Draw the menu bar to
select the mode.
 Auto - Setup Auto negotiation.
 Full - Force sets Full-Duplex mode.
 Half - Force sets Half-Duplex mode.

Flow Control When Auto Speed is selected for a port, this section indicates the flow control
capability that is advertised to the link partner.
When a fixed-speed setting is selected, that is what is used.
Current Rx column indicates whether pause frames on the port are obeyed.
Current Tx column indicates whether pause frames on the port are transmitted.
The Rx and Tx settings are determined by the result of the last
Auto-Negotiation.
Check the configured column to use flow control.
This setting is related to the setting for Configured Link Speed.
Buttons
: Click to apply changes.