Interlogix NS3500-28T-4S User Manual - Manual (Page 234)

234
The page includes the following fields:
Object Description
 Server Definition Set the server definition.
 Server IP Address of the Radius server IP/name.
 Authetication Port The UDP port to use on the RADIUS Authentication Server. If the port is set to
0 (zero), the default port (1812) is used on the RADIUS Authentication Server.
 Acct Port The UDP port to use on the RADIUS Accounting Server. If the port is set to 0
(zero), the default port (1813) is used on the RADIUS Accounting Server.
 Key String The shared key - shared between the RADIUS Authentication Server and the
switch.
 Timeout for Reply The Timeout, which can be set to a number between 1 and 30 seconds, is the
maximum time to wait for a reply from a server.
If the server does not reply within this timeframe, we will consider it to be dead
and continue with the next enabled server (if any).
RADIUS servers are using the UDP protocol, which is unreliable by design. In
order to cope with lost frames, the timeout interval is divided into 3 subintervals
of equal length. If a reply is not received within the subinterval, the request is
transmitted again. This algorithm causes the RADIUS server to be queried up
to 3 times before it is considered to be dead.
 Retries Timeout is the number of seconds, in the range 1 to 10, to wait for a reply from
a RADIUS server before retransmitting the request.
 Server Priority Set the server priority.
 Dead Time The Dead Time, which can be set to a number between 0 and 3600 seconds, is
the period during which the switch will not send new requests to a server that
has failed to respond to a previous request. This will stop the switch from
continually trying to contact a server that it has already determined as dead.
Setting the Dead Time to a value greater than 0 (zero) will enable this feature,
but only if more than one server has been configured.
 Usage Type Set the usage type. The following modes are available:

Login

802.1X

All