Interlogix NS3500-28T-4S User Manual - Manual (Page 98)

98
 None of the ports in a link aggregation can be configured as a mirror source port or a mirror target port.
 All of the ports in a link aggregation have to be treated as a whole when moved from/to, added or deleted from a
VLAN.
 The Spanning Tree Protocol will treat all the ports in a link aggregation as a whole.
 Enable the link aggregation prior to connecting any cable between the switches to avoid creating a data loop.
 Disconnect all link aggregation port cables or disable the link aggregation ports before removing a port link
aggregation to avoid creating a data loop.
It allows a maximum of 8 ports to be aggregated at the same time. The Managed Switch support Gigabit Ethernet ports
(up to 8 groups). If the group is defined as a LACP static link aggregationing group, then any extra ports selected are
placed in a standby mode for redundancy if one of the other ports fails. If the group is defined as a local static link
aggregationing group, then the number of ports must be the same as the group member ports.
Use the Link Aggregation Menu to display or configure the Trunk function. This section has the following items:
 LAG Setting Configures load balance algorithm configuration settings
 LAG Management Configures LAG configuration settings
 LAG Port Setting Configures LAG port settings
 LACP Setting Configures LACP priority settings
 LACP Port Setting Configure LACP configuration settings
 LAG Status Display LAG status / LACP information