Interlogix NS3500-28T-4S User Manual - Manual (Page 299)

299
to match this entry.

Don’t Care : Any value is allowed ("don't-care").
PSH Specify the TCP "Push Function" (PSH) value for this ACE.

Set : TCP frames where the PSH field is set must be able to
match this entry.

Unset : TCP frames where the PSH field is set must not be able
to match this entry.

Don’t Care : Any value is allowed ("don't-care").
RST  Specify the TCP "Reset the connection" (RST) value for this
ACE.
Set : TCP frames where the RST field is set must be able to
match this entry.
 Unset : TCP frames where the RST field is set must not be able to
match this entry.

Don’t Care : Any value is allowed ("don't-care").
SYN Specify the TCP "Synchronize sequence numbers" (SYN) value for
this ACE.

Set : TCP frames where the SYN field is set must be able to
match this entry.

Unset : TCP frames where the SYN field is set must not be able
to match this entry.

Don’t Care : Any value is allowed ("don't-care").
FIN Specify the TCP "No more data from sender" (FIN) value for this ACE.

Set : TCP frames where the FIN field is set must be able to match
this entry.

Unset : TCP frames where the FIN field is set must not be able to
match this entry.

Don’t Care : Any value is allowed ("don't-care").
 Type of Service Specify the type pf service for this ACE.

Any : No specifc type of service is specified (destination port status is
"don't-care").

DSCP : If you want to filter a specific DSCP with this ACE, you can enter a
specific DSCP value. A field for entering a DSCP value appears. The
allowed range is 0 to 63. A frame that hits this ACE matches this DSCP
value.