Interlogix NX-6V2 Rev C Installation Manual - Manual (Page 15)

Chapter 2: Reporting codes
NX-6V2 Control Panel Installation Manual 11
System clock
To set the system clock:
1. Enter *, 9, 7, master code. The Service LED begins flashing.
2. Enter the clock time (military time). Hour: 00 through 23, where 00 is
midnight, 01 is 1:00 a.m., 23 is 11:00 p.m. Minutes: 00 to 59. For example,
3.25 a.m. = 0, 3, 2, 5; and 5:00 p.m. = 1, 7, 0, 0.
User codes
To change the user codes:
1. Enter *, 5, master code. The Ready LED begins flashing.
2. Enter the two-digit user number (for example, 03 for user 3). The maximum
number of users is 40.
3. Enter the new user code designated for that individual. The Ready LED
begins flashing, indicating the code was accepted. If the code was rejected, a
beep sounds three times.
If another user code needs to be programmed, repeat the process.
4. Press # while the Ready LED is flashing to exit the user code programming
mode.
User authority level
To assign user authority levels:
1. Enter *, 6, master code. The Ready LED begins flashing.
2. Enter the two-digit user number. The Ready LED illuminates and the Instant
LED begins flashing.
3. Turn on the LED for the features you want. See Table 5 on page 12 for a
description of each LED.
4. Enter *. The Instant LED will illuminate steady.
5. Now you are in partition enable mode. This tells the system what partition this
user can arm/disarm. LEDs 1 and 2 illuminate for each partition that the user
has authorization for. To change any of these numbers, press 1 or 2 to toggle
the corresponding LED off/on, indicating the user is assigned or not assigned
access to that partition.
6. Enter *. This returns you to step 2, where you can enter another user number
to assign attributes for. You may continue this procedure until you have