Interlogix NX-6V2 Rev C Installation Manual - Manual (Page 39)

Chapter 2: Reporting codes
NX-6V2 Control Panel Installation Manual 35
Location 41 - Special features
Location 41 has one segment of feature selection data.
Segment 1
1. On enables the six-digit code option. If enabled, all arm/disarm codes and the go to program
code are six digits. The default user 1 code is 123456.
Caution: If you enable this option verify that the go to program code is a six -digit code before
exiting programming.
2. On requires code entry for *, 9, 8 (dial call back phone number) and *, 9, 9 (answer incoming
call for download) functions.
3. On enables auto cancel/abort.
4. On enables walk test mode.
5. On enables auto force arming with keyfob or keyswitch.
6 to 8 Reserved (do not program)
Locations 42 and 43 - Go to program code and
authorization
Location 42 - Go to program code
Location 42 has six segments of numerical data. Use this location to program the
go to program code. This location contains either a four or six-digit code. If the
six-digit code option is enabled in Location 41, this code must contain six digits. If
not enabled in Location 41, the last two segments (digits) are ignored. With the
NX-6V2 disarmed, use the go to program code to enter program mode. Defaults
for segments 1 to 6 are 9. 7, 1, 3, 0, 0.
Location 43 - Go to program code and authorization
Location 43 has two segments of feature selection data. The go to program code
can be used as a standard arm/disarm code. When using the code to arm or
disarm, the user ID is 255. This code cannot be changed in run mode.
Segment 1
1. Reserved.
2. On enables go to program code as an arm only.
3. On enables go to program code as an arm only after closing.
4. On enables go to program code as a master arm/disarm code (c an change user codes).
5. On enables go to program code as a arm/disarm code.
6. On enables go to program code to bypass zones.
7. On enables go to program code opening and closing reports.
8. Reserved.
Segment 2
1. On enables go to program code for partition1.
2. On enables go to program code for partition 2.
3. to 8 - Reserved