Interlogix NX-6V2 Rev C Installation Manual - Manual (Page 17)

Chapter 2: Reporting codes
NX-6V2 Control Panel Installation Manual 13
To enter program mode:
1. Press *, 8. The five function LEDs (Stay, Chime, Exit, Bypass, and Cancel)
begin flashing.
2. Enter the go to program code (default 9, 7, 1, 3). If the go to program code
entry is valid, the Service LED flashes, and the five function LEDs illuminate.
You are now in program mode and can select the module to program.
Select the module to program
Since all modules connected to the NX-6V2 are programmed through the
keypad, the module you are programming should be the first entry. To select the
module to program, enter 0, #. The 0 is the module number of the control, and #
is the entry key. You can find other module entry numbers in the module
documentation and in Table 15 on page 60.
Once you enter the module number, the Armed LED illuminates, indicating it is
waiting for you to enter a programming location.
To program a location:
1. To access any location, enter the desired programming location, followed by
#. If the location is a valid location, the Armed LED extinguishes, the Ready
LED illuminates, and the binary data for the first segment of the location is
shown by the Zone LEDs.
While entering new data, the Ready LED begins flashing to indicate a data
change in process.
2. Press * to store the newly entered data. The keypad advances to the next
segment and displays its data. Repeat this procedure until the last segment is
reached.
3. To move to another location after exiting a location (Armed LED illuminated):
Press the Police (badge) key for the next sequential location.
Press the Fire (flame) key for the previous location.
Press the Emergency (cross) key for the same location.
4. To review the data in a specific location, repeat the procedure, pressing * but
with no numeric data entry. Each time you press *, the programming data of
the next segment displays.
To exit the current programming location:
1. Press *. The Ready LED goes off and the Armed LED goes on. You must
press * to save the data.
2. To exit before the last segment, press #. The Armed LED illuminates.