Interlogix NX-6V2 Rev C Installation Manual - Manual (Page 19)

Chapter 2: Reporting codes
NX-6V2 Control Panel Installation Manual 15
Feature selection data
Feature selection data displays the current condition (on or off) for eight features
associated with the programming location and segment selected. Pressing a
button on the touchpad (1 to 8) that corresponds to the feature number within a
segment toggles (on/off) that feature. You can select numerous features within
one segment.
To enter feature selection data:
1. Press a numeric key from 1 to 8 to select the feature. The corresponding LED
illuminates (feature is on).
2. Press the number again, and the LED extinguishes (feature is off).
3. If you want to select all eight features of a segment, press 1, 2, 3, 4, 5, 6, 7, 8.
LEDs 1 to 8 illuminate as you press the keys indicating that those features are
enabled. The features not enabled display a hyphen (-) on an LCD touchpad.
4. After selecting the desired settings for features in the segment, press * to
enter the data and advance to the next segment of the location.
Note: When you are in the last segment of a location and press * to enter the
data, you exit that location. This turns the Ready LED off and the Armed LED on.
You are now ready to enter another programming location.
Loading factory defaults
To load factory defaults, enter program mode, enter the device address and
number, and then enter 9, 1, 0, #. The keypad beeps three times indicating that
loading is in progress. The process takes about 6 seconds. You cannot exit the
location until loading is completed.
Enrolling modules and keypads
The NX-6V2 automatically finds and stores all keypads, zone expanders,
wireless receivers, and other modules connected to the data terminal into the
NX-6V2 memory. This allows these modules to be supervised by the control
panel.
To enroll the modules:
1. Enter program mode and program the desired settings for each module.
2. When you exit program mode, the NX-6V2 automatically enrolls the devices.
The enrolling process takes about 12 seconds, during which time the Service
LED illuminates. If a speaker is attached to the NX-6V2, it clicks at this time. If