Interlogix NX-6V2 Rev C Installation Manual User Manual
Page 46
Chapter 2: Reporting codes
42
NX-6V2 Control Panel Installation Manual
Location 72
Telephone line cut/restore
communicator code
Program the digits sent for a 4+2 format if telephone
line cut reporting is enabled.
Segments 1 and 2 = telephone line cut reporting
Segments 3 and 4 = telephone line cut restore
Location 73
Ground fault/restore communicator
code
Program the digits sent for a 4+2 format if ground fault
reporting is enabled.
Segments 1 and 2 = ground fault reporting
Segments 3 and 4 = ground fault restore
Location 74
Expander trouble/restore communicator
code
Program the digits sent for 4+2 format if expander
trouble reporting is enabled (Location 37).
Segments 1 and 2 = expander trouble tamper
Segments 3 and 4 = expander trouble restore
Location 75
Fail to communicate communicator
code
Program the digits sent for a 4+2 format that are sent if
the fail to communicate reporting is enabled (Location
37).
Location 76
Log full communicator code
Program the digits sent for a 4+2 format if the log full
reporting is enabled (Location 37).
Location 77
Opening communicator code
Program the digits sent for a 4+2 format if the opening
report is enabled (Location 23).
Location 78
Closing communicator code
Program the digits sent for a 4+2 format if the closing
report is enabled (Location 23).
Location 79
Autotest communicator code
Program the digits sent for a 4+2 format if the autotest
or manual test is enabled (Location 37).
Location 80
Recent closing and exit error
communicator code
Program the digits sent for a 4+2 format if recent
closing and/or exit error reporting is enabled (Location
23). Segments 1 and 2 = recent closing report
Segments 3 and 4 = exit error reporting
Location 81
Start program and end program
communicator code
Program the digits sent for a 4+2 format if start/end
programming reporting is enabled (Location 37).
Segments 1 and 2 = start program reporting
Segments 3 and 4 = end program reporting
Location 82
End download communicator code
Program the digits sent for a 4+2 format if end
download reporting is enabled (Location 37).
Segments 1 and 2 = Reserved
Segments 3 and 4 = end download reporting
Location 83
Cancel communicator code
Program the digits sent for a 4+2 format if cancel
reporting is enabled (Location 23).