Interlogix NX-6V2 Rev C Installation Manual - Manual (Page 28)

Chapter 2: Reporting codes
24 NX-6V2 Control Panel Installation Manual
Segment 1
1. Alarms and alarm restores.
2. Opening and closings.
3. Zone bypass and bypass restore.
4. Zone trouble and trouble restores.
5. Power fail, low battery, power restore, and low battery restore.
6. Bell cut, telephone line cut, bell cut restore, telephone line restore.
7. Test reports.
8. Start/end programming, download complete.
Segment 2
1. Zone and box tamper and tamper restore.
2. Auxiliary power overcurrent and restore.
3. Sensor missing and restore.
4. Sensor low battery and restore.
5. Expander trouble and restore.
6. Fail to communicate.
7. Zone activity monitor.
8. Reserved.
Location 17 - Phone 3 partitions reported
Location 17 has one segment of feature selection data. Use this location to
program when events are to be reported to a phone number are based upon the
partition (1 or 2) regardless of the event. Enter 1 for partition 1 or enter 2 for
partition 2. If this location is used, Location 16 should be programmed as 0.
Location 18 - Custom communicator format
Location 18 has four segments of feature selection data. Use this location to
program the communicator format used to transmit to the receiver connected to
phone 3. Refer to your central station receiver documentation to determine which
format is compatible. Select a format from Table 6 on page 18 . If you need a
format other than those listed, review the override options described in this
location to build the appropriate format.