Interlogix NX-6V2 Rev C Installation Manual - Manual (Page 68)

Appendix B: Reporting codes
64 NX-6V2 Control Panel Installation Manual
Programming worksheet
Use the following worksheet to check location defaults and record location
settings. Locations with multiple segments will show defaults as multiple numbers
separated by commas. Defaults are shown in bold.
Table 18: Location defaults and settings
Loc. Description Default Setting
0 Phone 1 (20 segments) 14 (each segment)
1 Phone 1 account code 10, 10, 10, 10, 10, 10
2 Phone 1 communicator format 0
3 Phone 1 dial attempts
Backup control 8
0
4 Phone 1 events reported
Segment 1
1 = Alarm s and restores
2 = Open/close
3 = Bypass
4 = Zone trouble
5 = Pow er trouble
6 = Siren and telephone fault
7 = Test reports
8 = Program, download and log full
Segment 2
1 - Tam pers
2 = Short circuit and ground fault
3 = Sensor lost
4 = Sensor low battery
5 = Expander trouble
6 = Failure to com municate
7 = Zone activity m onitor
8 = Reserved
5 Partitions reported to phone 1
Segment 1
1 = Partition 1
2 = Partition 2
6 Phone 2 (20 segments) 14 (each segment)
7 Phone 2 account code 10, 10, 10, 10, 10, 10
8 Phone 2 communicator format 0
9 Phone 2 dial attempts
Backup control 8
0
10 Phone 2 events reported
Segment 1
1 = Alarms and restores
2 = Open/close
3 = Bypass
4 = Zone trouble
5 = Pow er trouble
6 = Siren and telephone fault
7 = Test reports
8 = Program, dow nload and log full
Segment 2
1 - Tampers
2 = Short circuit and ground fault
3 = Sensor lost
4 = Sensor low battery
5 = Expander trouble
6 = Failure to communicate
7 = Zone activity monitor
8 = Reserved