Interlogix NX-6V2 Rev C Installation Manual - Manual (Page 79)

NX-6V2 Control Panel Installation Manual 75
Glossary
Abort In enabled, the NX-6V2 waits the number of seconds
programmed in Location 40 prior to sending an alarm. During
this delay time, the Cancel LED flashes. To abort the report,
type in a code and press the Cancel key. The LED extinguishes.
If the report is not aborted within the allotted time, the LED
extinguishes when the report is sent (a dialer delay must be
enabled). (Locations 40 and 110 to 169)
AC fail/lower battery
report/warning If programmed, the NX-6V2 reports AC failure and/or low
battery conditions to the central station. It also sounds the
keypad immediately upon detection of the condition. If
programmed, the NX-6V2 delays the AC failure report/warning.
(Locations 37 and 39)
AC power/low battery sounder
alert If enabled, the NX-6V2 beeps the keypad sounder upon arming
or disarming if the AC power is missing or a low battery is
detected. (Location 23)
Arm/disarm codes The NX-6V2 has eight four-digit or six-digit codes to arm/disarm
the control panel. All codes must have the same number of
digits. The default for user 1 is 1234 when using a four-digit
code, or 123456 for a six-digit code. Use this code to enter the
new arm/disarm codes. (Location 41)
Automatic arming If programmed, the NX-6V2 auto arms at a specified time. At
this time, the keypad beeps for 50 seconds before the panel
arms. When a code is entered on the keypad, the arming
process stops. The NX-6V2 attempts to arm after every 45
minutes of inactivity until the next opening time or until the
system is armed. The 45-minute timer is extended when there is
activity in the building that causes the Ready LED to turn off and
on. The user code is 97 if closing reports are sent. (Locations
23, 52 to 55)
Automatic bypass/instant
arming When enabled, the control panel automatically bypasses interior
follower zones if an exit is not detected during the exit delay
time. Entry delay zones are made instant. (Location 23)