Interlogix NX-6V2 Rev C Installation Manual - Manual (Page 44)

Chapter 2: Reporting codes
40 NX-6V2 Control Panel Installation Manual
Segment 2 - Program the minutes after the hour of the closing/autoarm time. Default is 0
Location 54 - Days of week the system is open
Location 54 has eight segments of feature selection data. Use this location to
select which days of the week the system is open. On these days, arm only after
close window codes are able to arm and disarm during open window. On days
not selected here, arm only after close window codes are not disarmed
(Locations 52 and 53).
Note: If the system is not programmed to be opened and is programmed to auto
arm, the NX-6V2 tries to arm every 45 minutes for the duration of the closed
period unless auto retry is disabled (Location 55).
For each segment (1 to 8), select from the following:
1 = Sunday 2 = Monday 3 = Tuesday 4 = Wednesday
5 = Thursday 6 = Friday 7 = Saturday 8 = Reserved
Location 55 - Days of week the system will automatically arm
Location 55 has eight segments of feature selection data. Use this location to
select which days the system autoarms. If a zone is faulted when the panel tries
to autoarm, the zone bypasses. Default is 0.
1 = Sunday 2 = Monday 3 = Tuesday 4 = Wednesday
5 = Thursday 6 = Friday 7 = Saturday 8 = Disable 45 minute
retry timer
Locations 56 to 83 - 4+2 format communicator codes
Use Locations 46 to 83 only when reporting events to a pager or using a slow
format such as 4+2. When using Contact ID or SIA, you do not need to program
these locations. There are eight segments of numerical data for each location
and the default for all segments is 0.
The digit programmed in each of the segments in these locations is sent as the
upper hex digit in place of the alarm event code. The zone ID or user ID is
reported as the lower hex digit (1-F). For example, if the zone ID or user ID is 3,
the 4+2 lower digit is 3. If the segment is left as 0 and the feature is enabled, the
NX-6V2 reports A.