Interlogix NX-6V2 Rev C Installation Manual - Manual (Page 29)

Chapter 2: Reporting codes
NX-6V2 Control Panel Installation Manual 25
Segment 1
1. On for 1800 Hz transmit; off for 1900 Hz.
2. On for 2300 Hz handshake; off for 1400 Hz.
3. On for cksum parity; off for double round parity.
4. On for two-digit event code; off for one-digit event code.
5. Reserved.
6. Reserved.
7. On for 20 pps; off for 10 to 40 pps.
8. On for 10 pps: off for 20 or 40 pps.
Segment 2
1. On for pager format (no handshake required).
2. On for 1400/2300 handshake.
3. Reserved.
4. Reserved.
5. On for contact ID.
6. On for SIA.
7. On for contact ID or 4+3.
8. On for DTMF.
Segment 3 and 4 - Reserved
Locations 19 to 22 - Downloading
Location 19 - Download access code
Location 19 has eight segments of numerical data. Use this location to program
the eight-digit access code that the NX-6V2 must receive from the downloading
software before the panel permits downloading to occur. The defaults for the
segments are 8, 4, 8, 0, 0, 0, 0, 0.
Location 20 - Download number of rings to answer
Location 20 has one segment of numerical data. Use this location to program the
number of rings to answer for a download. Enter a number from 0 (disabled) to
15. The NX-6V2 answers on the same number of rings. Default is 8.
Location 21 - Download control
Location 21 has one segment of feature selection data. Use this location to
program the feature selections for controlling the download sessions.