Interlogix NX-6V2 Rev C Installation Manual - Manual (Page 24)

Chapter 2: Reporting codes
20 NX-6V2 Control Panel Installation Manual
Location 4 - Phone 1 events reported
Location 4 has two segments of feature selection data. Use this location to select
those events reported to phone 1.
• If you do not want dual or split reporting, use Location 4 to select all events to
phone 1. Location 5 should be left at the factory default of 0.
• If you want dual or split reporting and the split is based on the event type
(alarm, open/close, etc.), use Location 4 to select only those events that are
reported to phone 1.
• If you don’t want events reported to phone 1, program 0 in Location 4
(disabling all options).
Segment 1
1. Alarms and alarm restores.
2. Opening and closings.
3. Zone bypass and bypass restore.
4. Zone trouble and trouble restores.
5. Power fail, low battery, power restore, and low battery restore.
6. Bell cut, telephone line cut, bell cut restore, telephone line restore.
7. Test reports.
8. Start and end programming, download complete.
Segment 2
1. Zone and box tamper and tamper restore.
2. Auxiliary power overcurrent, ground fault, and restore both.
3. Sensor missing and restore.
4. Sensor low battery and restore.
5. Expander trouble and restore.
6. Fail to communicate.
7. Zone activity monitor.
8. Reserved.
Location 5 - Phone 1 partitions reported
Location 5 has one segment of feature selection data. Use this location to
program when events are to be reported to a phone number are based upon the
partition (1 or 2) regardless of the event. Enter 1 for partition 1 or enter 2 for
partition 2. If this location is used, Location 4 should be programmed as 0.
Location 6 - Phone 2
Location 6 has 20 segments of numerical data. Use this location to program
phone 2. The default for each segment is 14.
• To program a delay of 4 seconds, enter 13 in the appropriate segment.
• To program tone dialing, enter 15 in the segment where tone dialing begins.
• If the entire number is tone dialing, enter 15 in the first segment.