LINK Systems OmniLink 5000 User Manual
Page 27
4.9
Stroke
Mode Single Stroke
Drive
Speed
Stroke
Speed
SPM
SPM
0
0
Order
Counter
PC STATUS
Counter OFF
PRESS
CONTROL
MOTOR
SPEED
TONNAGE
MONITOR
AUTO
SETS
DIE
PROTECTION
EXIT
0
0
SPM
0
% LOAD
161
READY TO STROKE
TOP
AUXILIARY
COMM.
DIAGNOS
OPERATOR
STATON
Brake Monitor
Limit
Stoptime
Top Stroke Stop
0200
208
mSec
Mid Stroke Stop
0250
0
mSec
Clutch time
0275
0250
mSec
Limit
Actual
Auto Single Stroke Time ………
5
Sec
Feed Complete Position ……… 25
Degs
Cont. on Demand Time ……….
10
Mins
Auxiliary Equipment Message
Option is not Installed
Reason for the Last Stop
Auto Stop on Top
Present Running Status
Stop Took Too Long
RESET
ERROR
Figure 4.5 Reset Error
Section 4.2.11 Press Operator Station
If an operator station select turns Off (input goes High), a stroke in progress is aborted and further stroking
prevented until acknowledged by the operator. The present running status will indicate “Press Oper. Station”
and the OPER. STATION softkey must be selected. The screen shown in Figure 4.6 is provided to indicate
which station has been turned Off. If this station has been intentionally turned Off, the VERIFY softkey
should be pressed to save this as the present combination of active operator stations. No error is generated
if a station is turned On (input goes Low), and the additional station is added to the present combination of
active operator stations. The OPER. STATION softkey can also be used to view the present station select
status. Verification is required only when one or more stations are turned Off.
Stroke
Mode Single Stroke
Drive
Speed
Stroke
Speed
SPM
SPM
0
0
Order
Counter
PC STATUS
Counter OFF
OPERATOR
STATIONS
VERIFY
EXIT
0
0
Press Oper. Station
TOP
Station Number Status
01
ON
02
OFF *
03
ON
04
ON
Any station (shown above) indicated with an ‘*’ has
changed from ON to OFF. Make certain that this is an
intended change and that each operator has an active
station. Press the VERIFY key if deactivation of the
station is intended.
Warning! Failure to provide an active operator station
for each operator may result in serious injury or death
if two hand controls are used as safety devices
Figure 4.6 Press Operator Station
Section 4.3 Stroke Mode Selection
The present stroking mode of the press control is displayed at the top of the LCD. The mode is changed by
placing the stroke mode selector switch in the MODE SELECT position, with the Program/Run switch in