LINK Systems OmniLink 5000 - Manual (Page 68)

5.21
Section 5.4.6.4 Set Configuration Code
Selecting the SET CONFIG. CODE softkey in the Access Configuration Menu, Figure 5.9, will display
the Configuration Code screen, Figure 5.11. This screen allows the Configuration Code to be changed.
This is the configuration code that protects Top Stop Calibration, Machine Parameters, Lubrication
Systems Configuration, Operator Terminal Configuration, Restricted Programmable Limit Switch Setting,
Names and Messages, Counter Configuration, Tonnage Monitor Configuration, Die Protection
Configuration, and Auto Setups Configuration. It is imperative that this code be give to authorized
personnel who are familiar with the control and with the consequences of incorrect parameter settings.
Stroke
Mode Single Stroke
Drive
Speed
Stroke
Speed
SPM
SPM
200
0
Order
Counter
PC STATUS
Counter OFF
CONFIG.
CODE
CHANGE
NUMBER
0 0
Program/Run Switch
TOP
EXIT
This Configuration Code is used to gain access to the
configuration area of the Press Control. Tonnage
Monitor, and other systems. This code should ONLY be
known to authorized setup personnel trained in the
meaning and use of the screens it protects. Make sure you
keep the code in a safe place. If it is lost, you will
have to contact the factory to restore access to the
system!
Configuration Code: ***
Figure 5.11 Setting Configuration Code
The configuration code is set at the factory. It is suggested that this code not be changed unless the
security of the configuration code has been jeopardized. If a configuration code has been obtained by
personnel who do not require access to the configuration parameters, it must be changed. When this
code is changed, the previous code will no longer be valid. The value of the new code should be
documented and stored in a secure place.
If a current code value is lost, the factory must be consulted.
To change the configuration code press the Change Number softkey , enter the new code, and press the
ENT key.
Section 5.4.7 Configure Auxiliary Communications
The AUXILIARY COMM. SETUP softkey provides access to the configuration screens for the
communication options These options include serial communication ports for interfacing to electronic