LINK Systems OmniLink 5000 - Manual (Page 9)

2.1
Section 2 Operator Terminal
Section 2.1 LCD Description
Figure 2.1 shows the operator terminal front panel. This panel consists of a color LCD display, keypad, and
key switch.
0
Mode
Stroke
Single Stroke Speed
Stroke
Drive
Speed
0
SPM
0 SPM
Order
Counter
PC STATUS
Counter OFF
PRESS
CONTROL
SETS
AUTO
TONNAGE
MONITOR
SWITCH
LIMIT
DIE
PROTECTION
JOB
SETUPS
COUNTERS
2PQL/LQN ,, /&'
23(5$725 7(50,1$/
MAIN
MENU
MOTOR
SPEED
SPM
0 % LOAD
0
JOB NUMBER DESCRIPTION
100000 FRONT BRACKET
COUNTER LIMIT QUANTITY STATE
ORDER 2000 7 ON
STATUS:
ALL CONDITIONS OKAY
STATUS:
ALL CONDITIONS OKAY
STATUS:
ALL CONDITIONS OKAY
STATUS:
ALL CONDITIONS OKAY
BATCH 500 7 ON
READY TO STROKE
Figure 2.1 OmniLink Color LCD Operator Terminal
The color liquid crystal display (LCD) is divided into fixed areas. Crankshaft position and current stroking
mode of the press are displayed in the upper left hand corner of the color LCD screen. The crankshaft
position information is updated 10 times a second. This angular position is displayed in both graphical and
numerical format. For speeds less than sixty strokes per minute, the pointer which is enclosed in a circle will
rotate to visually indicate the angular position of the crankshaft and top and bottom of stroke indicators will
appear. For eccentric drive presses the top dead center of the stroke is equivalent to 0 degrees. The bottom
dead center of the stroke is always 180 degrees. In addition to the rotating pointer, there is a rectangular box
enclosed in the circle. When the slide is stopped at the top of the stroke, within +/- 5 degrees of top, this box
will be green with the letters “TOP”. When the slide is stopped at the bottom of the stroke, within +/- 5
degrees of bottom dead center, the box will be yellow with the letters “BOT”. For speeds greater than sixty
strokes per minute, two rotating arrows will appear in the circle. These rotating arrows indicate crankshaft
motion.
The remainder of the top portion of the screen displays four user selected items. These four user selected
items can be chosen by the user from a list of ten. These ten items are:
-Drive Speed
-Stroking Speed
-Auto Press Speed (Drive speed when press is not stroking and crankshaft speed when press is
stroking
-Press Control Status