LINK Systems OmniLink 5000 - Manual (Page 70)

5.23
Stroke
Mode Single Stroke
Drive
Speed
Stroke
Speed
SPM
SPM
200
0
Order
Counter
PC STATUS
Counter OFF
INPUT
NAMES
CHANGE
NAME
AUXILIARY
EQUIPMENT
0 0
Program/Run Switch
TOP
EXIT
Press Control Input Descriptions
Num Type Stop Description
In58 T-Stop MATERIAL LUBE LOW
In59 T-Stop --------------------------------
In60 T-Stop --------------------------------
In61 T-Stop --------------------------------
In62 T-Stop --------------------------------
In63 T-Stop --------------------------------
In64 T-Stop --------------------------------
In65 E-Stop PLC Stop
In66 E-Stop --------------------------------
In67 E-Stop --------------------------------
In68 E-Stop --------------------------------
In69 M-Stop --------------------------------
In70 M-Stop --------------------------------
In71 M-Stop --------------------------------
In72 M-Stop --------------------------------
Figure 5.13 Editing the Third Input
Board Descriptions
Section 5.6.2 Aux. Equipment Messages
Depressing the AUXILIARY EQUIPMENT softkey on the Input Names menu, Figure 5.13, will display
the Auxiliary Names menu, Figure 5.14. This menu allows the user to enter messages for equipment
external to the press control. Each message is forty characters in length, and is assigned a message number
from 000 to 127. The message number corresponds to the binary pattern that must be provided to the
operator terminal's parallel input port. The NEXT GROUP softkey can be used to display additional
messages.
Stroke
Mode Single Stroke
Drive
Speed
Stroke
Speed
SPM
SPM
200
0
Order
Counter
PC STATUS
Counter OFF
AUXILIARY
NAMES
CHANGE
NAME
NEXT
GROUP
0 0
Program/Run Switch
TOP
EXIT
Auxiliary Equipment Message ON
Number Description
000 Transfer Okay
001 Transfer Part Sensor # 1 Fault
002 Transfer Part Sensor # 2 Fault
003 Transfer Part Sensor # 3 Fault
004 Transfer Part Sensor # 4 Fault
005 Transfer Stopped Waiting on Material
007 -------------------------------------------------------------------
008 -------------------------------------------------------------------
009 -------------------------------------------------------------------
010 -------------------------------------------------------------------
011 -------------------------------------------------------------------
012 -------------------------------------------------------------------
013 -------------------------------------------------------------------
014 -------------------------------------------------------------------
015 -------------------------------------------------------------------
OPTION
ON/OFF
ERASE
NAME
Figure 5.14 Edit Auxiliary Equipment
Names
This option can be turned On or OFF. To change the On/Off status, press the OPTION ON/OFF softkey.
To edit a description position the cursor on the description and depress the CHANGE NAME softkey.
The text edit box will appear. After the correct description is entered press the ENT key.