LINK Systems OmniLink 5000 - Manual (Page 34)

4.16
descriptions to particular outputs of the current job. The menu in Figure 4.9 shows the output descriptions
available as two pages of fifteen names. The output number to which the description is being assigned is
displayed at the bottom of the screen.
Stroke
Mode Single Stroke
Drive
Speed
Stroke
Speed
SPM
SPM
0
0 Order
Counter
PC STATUS
Counter OFF
PLS
NAMES
CHANGE
NAME
EXIT
0 0
READY TO STROKE
TOP
NO
NAME
NEXT
GROUP
Blow Off
Stock Oiler
Feed Initiate
Pilot Release
Kicker
Election Solenoid
Default Message 6
Default Message 7
Default Message 8
Default Message 9
Default Message 10
Default Message 11
Default Message 12
Default Message 13
Default Message 14
Select Description for PLS Channel # 03
Use 2244 Keys to select name, press ENT to select
Programmable Limit Switch Descriptions
Figure 4.9 Selecting PLS Names
To change an output name:
1. The operator must have access control. Access control is described in Section 3. If the user obtains
access control by using the password system, the user must be configured to have access to change
the programmable limit switch setpoints and names.
2. When viewing the Limit Switch menu, as shown in Figure 4.8, position the cursor on the channel that
is to be changed, press the CHANGE NAME softkey. The menu in Figure 4.9 is displayed, and the
cursor positioned to description 01.
3. Use the arrow keys to position the cursor onto the desired description and press the ENT key. All
names in memory are available by pressing the NEXT GROUP softkey.
The NO NAME softkey removes the name assigned to that channel, and the description process can be
aborted by pressing the EXIT softkey.
To edit a name description:
1. When viewing the PLS Names menu, use the arrow keys to position the cursor on the description that
is to be changed.
2. Press the CHANGE NAME softkey. A text entry screen will appear and the description can be
edited. See Section 2.7.