LINK Systems OmniLink 5000 User Manual
Page 37
4.19
access control by using the password system, the user must be configured to have access to recall jobs from
memory. The Select Job menu is shown in Figure 4.12. There are two ways to select a job. The first way
is to enter the job number, if it is known. The ENTER NUMBER softkey allows the user to enter the desired
job number directly into the operator terminal, which automatically searches the file system and retrieves the
job if located. The second way is to select the job from the screen. Select a job by using the NEXT GROUP
key to locate the page that the job is on, and then using the arrow keys to position the cursor on the correct
job. With the cursor on the correct job, depress the SELECT softkey.
Stroke
Mode Single Stroke
Drive
Speed
Stroke
Speed
SPM
SPM
0
0
Order
Counter
PC STATUS
Counter OFF
SELECT
JOB
SELECT
EXIT
0
0
PROGRAM/RUN SWITCH
TOP
NEXT
GROUP
ENTER
NUMBER
JOB NUMBER
DESCRIPTION
000000001
FIRST EXAMPLE
000000002
SECOND EXAMPLE
000000003
THIRD EXAMPLE
000000004
FOURTH EXAMPLE
000000005
FIFTH EXAMPLE
000000006
SIXTH EXAMPLE
000000007
SEVENTH EXAMPLE
000000008
EIGHTH EXAMPLE
000000009
NINTH EXAMPLE
000000010
TENTH EXAMPLE
000000011
ELEVENTH EXAMPLE
000000012
TWELTH EXAMPLE
000000013
THIRTEENTH EXAMPLE
000000014
FOURTEENTH EXAMPLE
123456789
TWENTY CHARACTERS
Figure 4.12 Locating a job to recall
Either method of locating the desired job results in a request for final verification as shown in Figure 4.13.
After verifying that the job number and description are correct, the RECALL SETUP softkey replaces the
information in the current job with that of the requested one. During the recall process, the message
"Loading the Job" is displayed. When complete, the operator terminal returns to the job setups menu and
the current job information reflects the change.
Stroke
Mode Single Stroke
Drive
Speed
Stroke
Speed
SPM
SPM
0
0
Order
Counter
PC STATUS
Counter OFF
RECALL
JOB
EXIT
0
0
PROGRAM/RUN SWITCH
TOP
RECALL
SETUP
You Have Selected to RECALL:
Job Number
Description
000000001
FIRST EXAMPLE
WARNING! Always check to make certain that you are
recalling the correct setup. Recalling an incorrect
setup for a production process can result in bodily
injury and/or damage to machine or tooling.
RECALL SETUP when ready.
Figure 4.13 Recall a Job
Section 4.5.3 Erase Setup