KBC Networks ESML8P-PC2 - Manual (Page 14)

Manual-ESML8P-PC2_Series-Rev1211
Copyright © KBC Networks Ltd.
Page 14 of 110 www.kbcnetworks.com
3.1.2 Hanging the Industrial Switch
Follow the steps below to hang the industrial switch on the DIN rail.
1. First, position the rear side of the switch directly in front of the DIN rail. Make sure the top of
the clip hooks over the top of the DIN rail.
2. Push the unit downward.
3. Check the DIN-Rail clip is tightly fixed on the DIN rail.
4. To remove the industrial switch from the track, reverse the steps above.