1 ide compactflash connector, Table 5-3, Compactflash ide connector pin assignments, j1 – Artesyn CPCI-6200 Installation and Use (May 2015) User Manual
Page 111: Transition module preparation and installation
Transition Module Preparation and Installation
CPCI-6200 Installation and Use (6806800J66E)
111
5.5.1
IDE CompactFlash Connector
One 50-pin Type II CompactFlash card header connector located on both standard and MXP
versions of the CPCI-6115-MCPTM transition module provides the IDE interface to one
CompactFlash plug-in module. This CompactFlash interface is connected to the primary IDE
channel. The pin assignments for these connectors are as follows:
CompactFlash Selection Header (J2)
Table 5-2 On-Board Connectors and Headers (continued)
Connector/Header
Location
Table 5-3 CompactFlash IDE Connector Pin Assignments, J1
Pin
J1
Pin
1
GND
NO CONNECT
26
2
DD3
DD11
27
3
DD4
DD12
28
4
DD5
DD13
29
5
DD6
DD14
30
6
DD7
DD15
31
7
CS1FX1_L
CS3FX1_L
32
8
GND
NO CONNECT
33
9
GND
DIOR_L
34
10
GND
DIOW_L
35
11
GND
+5 V
36
12
GND
INTRQ1
37
13
+5 V
+5 V
38
14
GND
MASTER/SLAVE
39
15
GND
NO CONNECT
40
16
GND
DRESET_L
41
17
GND
DIORDY
42