Artesyn CPCI-6200 Installation and Use (May 2015) - Manual (Page 158)

Control via IPMI
CPCI-6200 Installation and Use (6806800J66E) 158
7.1.7 Sensor Device Commands
The IPMC supports the following sensor device commands.
Table 7-7 Supported Sensor Device Commands
Command
NetFn
(Request/Response) CMD
Comments
Get Device SDR Info 0x04/0x05 0x20 -
Get Device SDR 0x04/0x05 0x21 -
Reserve Device SDR Repository 0x04/0x05 0x22 -
Get Sensor Reading Factors 0x04/0x05 0x23 -
Set Sensor Hysteresis 0x04/0x05 0x24 -
Get Sensor Hysteresis 0x04/0x05 0x25 -
Set Sensor Threshold 0x04/0x05 0x26 Most of the threshold-based
sensors have fixed thresholds.
Before using this command,
check whether threshold setting
is supported by using the Get
Device SDR command.
Get Sensor Threshold 0x04/0x05 0x27 -
Set Sensor Event Enable 0x04/0x05 0x28 -
Get Sensor Event Enable 0x04/0x05 0x29 -
Rearm Sensor Events 0x04/0x05 0x2A -
Get Sensor Reading 0x04/0x05 0x2D -
Set Sensor Type 0x2E
Get Sensor Type 0x04/0x05 0x2F -
Set Event Receiver 0x04/0x05 0x00 -
Get Event receiver 0x04/0x05 0x01 -
Platform Event 0x04/0x05 0x02 -