Basler Electric BE1-851 - Manual (Page 6)

Manual
Revision and Date
Change
H, 09/03 • Updated the discussion on Current Measurement Functions on page 3-
1 and 3-2.
• In Table 4-11, changed “Disables” to “Enables” for the Initiate setting.
• Did a general update of Section 6, Reporting and Alarm Functions
including an update of Table 6-10, a rewrite of Oscillographic Records,
pages 6-24 and 6-25, and correction of screen or table references.
G, 06/02 • Revised instruction manual to focus on the use of BESTCOMS for
setting the relay.
• Equation errors in Appendix A were corrected.
F, 03/00 • Added paragraphs on Breaker Failure in Section 4.
• Updated the manual to reflect the sensing input type Gxxxxx units.
• Converted the entire manual to a single volume.
E, 12/99 • Changed the manual to a two-volume set.
• Updated the manual to reflect extended oscillographic reporting.
• Added Modes 5 and 6 to 62/162 timer functionality.
• Updated logic scheme tables and diagrams to reflect new default
settings.
• Changed all of the default settings.
• Removed the SP logic serial command but added the SA-LGC and RA-
LGC commands.
• Changed the sequence of events recorder maximum number of events
from 127 to 255 in all references.
D, 03/98 • Manual was revised to reflect improvements in embedded software
versions 2.29, 2.30, 2.31, and 2.32.
• SG-TARG and RSTKEY commands were added.
• Replaced the text after and including Current Demand Reporting of
Section 3 with new alarms and outputs information.
• Changed the BF Timer range in Section 1 from 100 - 999 ms to 50 -
999 ms.
• In Table 1-3 the “A” parameter of curve “P” was changed from 0 - 100 to
0 - 600.
• Added a new style chart, Figure 1-4, with S1 cover and DNP 3.0
options.
• Curve names in Tables 1-4 through 1-20 were changed to match the
names in Figures 1-5 through 1-20.
• Added a missing connection in the logic diagram, Figure 5-1.
• Added UL and CSA logos to the style label shown on the front cover
graphics.
—, 03/97 • Initial release
BESTCOMS™ Software
Version and Date
Change
2.07.00, 04/11 • Added Windows® 7 compatibility. (“G” version.)
2.06.00, 04/11 • Added Windows® 7 compatibility. (“H” version.)
2.06.00, 03/08 • Added “V” and “W” to Option 1 in Style Chart Drawing. (“G” version.)
• Added support for relays with “V” or “W” chosen for option 1. (“G”
version.)
2.05.01, 03/07 • Enhanced Settings Compare feature.
iv BE1-851 Introduction 9289900990 Rev R