Basler Electric BE1-851 - Manual (Page 8)

Application Firmware
Version and Date
Change
3.43.09, 03/03 • Added the capability of changing Modbus Password Security with the
ASCII command.
• Enhanced the 3 rd parameter {C} for the SP-CURVE command (user
programmable time curve).
• Insured year change update with IRIG connected, under all conditions.
3.43.07, 03/02 • Enhanced fault data capture.
• Improved operation of the front panel Reset key with resettable data.
• Improved the accuracy of oscillographic waveform amplitude.
• Enhanced SA-BKR mode; more than one setting can be entered.
• Improved the display of the reclose cycle.
• Improved settings change capability.
• Automatically display the Target screen on the HMI after fault.
• Added operation of the 43 switches on the HMI scroll list.
3.43.06, 02/02
2.43.06, 02/02
• Improved accuracy of oscillographic waveform amplitude
measurement.
• Added functionality of DNP Version 2 with BESTCOMS.
3.43.05, 02/02
2.43.05, 02/02
• Improved modes of operation for SA-BKR command used to read or set
alarm settings.
• Changed alarm functionality so that an alarm threshold value of zero
will disable the alarm.
• Mode settings entered with multiple digits now return an error. Only one
digit may be entered for a mode setting.
• Improved the BE1-851 to prevent “lockup” from issuing too many
settings changes at one time.
3.43.00, 02/00 • Updated the GF-VER and RG-VER commands to report Model Number
BE1-851G for style type Gxxxxx and Model Number BE1-851 for style
type Hxxxxx.
• Updated to support sensing type G (Florida Power Light) which
replaces 51Q with 151N, 50TQ with 250TN, and 150TQ with 350TN.
(This hex file version only works with style type Hxxxxx.)
3.42.01, 11/99 • Added DNP 3.0, Level 2 compliance. Requires Version 3.xx hardware.
• Added support for Version 3 hardware with additional memory.
• Oscillographic recording is as follows:
Feature Version 3.xx
Number of Oscillographic Records 16
Length of Oscillographic Records
15 cycles each
Sample Resolution 24 samples/cycle
• Improved target reporting function.
• The trip LED only latches when there are targets to be displayed on the
HMI. The “pickup” condition, indicated by the Trip LED flashing, is now
a higher priority than latching to indicate that targets are being
displayed on the HMI.
• Improved HMI Target screen format. Screen now reports targets in a
text format. Additional information such as fault current magnitudes and
time and date of the fault were moved to a lower menu branch so that
the targets are all that is displayed unless the user wants more detail.
• Added functionality to reset targets using a programmable logic
expression in addition to the HMI Reset key and the ASCII command
vi BE1-851 Introduction 9289900990 Rev R