NavCom SF-3050 Rev.B - Manual (Page 118)

SF-3050 User Guide – Rev B
 NMEA
Messages
The SF-3050 does not output NMEA messages by
default. NMEA messages must be scheduled by the
user.
 Base and Rover Navigation Setup
NavCom’s StarUtil-3000 provides Base and Rover
setup capabilities. Refer to the StarUtil-3000 User
Guide for details. The guide is included on the
supplied SF-3050 Product Configuration USB Flash
Drive, and also is available on the NavCom web site.
User Profiles
The SF-3050 utilizes commands or groups of
commands, known as User Profiles, to set the various
port assignments/parameters, navigation parameters,
and output message lists. The SF-3050 provides for
storage of up to 20 user profiles. A file with commonly
used user profiles is included on the supplied USB
flash drive.
To save the current configuration settings of the
receiver for future use, the user creates and names a
profile. A controller solution, such as StarUtil-3000, is
used to activate a user profile by its name.
The user may command the SF-3050 to reset all of
the user-controlled configuration parameters to the
factory default values (see the section, Profile NONE,
on next page).

A new profile sent to the receiver replaces the
currently used profile, but it does not
necessarily replace all the current parameter
settings. The new profile replaces only those
parameter settings that it specifies.
5-116