NavCom SF-3050 Rev.B - Manual (Page 24)

SF-3050 User Guide – Rev B
2. Mount the supplied Rover, Base, or Airborne
antenna. Locate the antenna in an area with a
360
° clear view of the sky.

Refer to Chapter 4/Antennae for additional
considerations and restrictions.
3. Connect the supplied GNSS antenna cable
(P/N 94-310261-3012LF) to the GNSS antenna.
Connect the other end of the cable to the TNC
connector, labeled ANT, at the rear of the
SF-3050.

Refer to Table 22 for longer cable lengths.
4. Perform these steps to setup power:
a. Plug the supplied AC power cord (P/N 73-
200002-0001LF) into the supplied Universal
AC/DC Power Adapter (P/N 82-020007-
3001LF). The adapter operates on either 120
or 240 VAC power.

The purchase of a separate appliance
cable may be necessary if the VAC
plug configuration needed is not the
standard 2-prong American connector.
b. Connect the female Positronic connector end
of the Power Adapter cable into the male
connector, labeled POWER, at the rear of the
SF-3050.
c. Plug the AC power cord into an AC receptacle.
5. Press the front panel On/Off switch to turn on the
SF-3050 (see Figure 39). All front panel LEDs
illuminate for a period of 3-5 seconds during
power-up. The Power/GNSS Status LED changes
from Red to Green.
1-22