NavCom SF-3050 Rev.B - Manual (Page 92)

SF-3050 User Guide – Rev B
6. Click the Send button. The receiver returns the
current USB Mode, Device or Host.
7. If the SF-3050 is not in USB Host Mode, type the
command [USBMODE]host.
8. Click the Send button.
9. Type the command [USBMODE] to verify that the
receiver is in USB Host Mode. Click the Send
button. The receiver returns Host as the current
USB Mode.
Logging
To log data to the USB flash drive, the messages to
be logged are first scheduled on a special port, fh1.
“fh” means “file handler”. The command [OUTPUT] is
used to schedule the messages.
1. Open StarUtil-3000, if not already open.
2. Schedule a message to be logged:
a. Type the appropriate [OUTPUT] command
string in the field at the bottom of the Input
Terminal window:
[OUTPUT](message), (timing), (interval), fh1
For example, to output PVT1B at 10Hz, the
command is:
[OUTPUT]PVT1B, ontime, 0.1, fh1
b. Click the Send button.
3. Repeat Step 2 to schedule all necessary
messages.

To simplify this process, a profile can
be configured to begin and end data
logging to the USB flash drive.
4. Type the command ‘[LOGFILE]start’.
3-90