NavCom SF-3050 Rev.E User Manual
Page 117
SF-3050 GNSS Product User Guide
– Rev E
3-91
StarUtil 3000:
NavCom‟s Windows™ based
control program, included on the supplied USB
Flash Drive (P/N 82-043000-0001). It is also
available on
NavCom‟s Web site or via
Customer Support.
Supplied Positronic 9-Pin Male to DB9S Data
Cable (P/N 94-310260-3006LF)
Positronic 9-Pin Male to USB 2.0 Host Receptacle
Data Cable (P/N 94-310271-3006LF). This cable
is not supplied with the SF-3050.
The USB Host Data Cable is available via a
NavCom authorized representative, or by
contacting the
Refer to the section above, USB Host Cable
(Option), for a detailed description of the cable.
Setup
The SF-3050 must be configured in USB Host Mode
to log data to a USB flash drive.
1. Connect the Positronic connector of the supplied
DB9S cable (P/N 94-310260-3006LF) to
COM1 - LAN of the SF-3050. Connect the DB9S
end to the computer.
2. Connect the Positronic connector of the USB Host
cable (P/N 94-310271-3006LF) to COM 2 - USB
of the SF-3050. Plug a USB flash drive into the
USB Host end of the cable.
3. Open StarUtil 3000 on the PC.
4. Locate the Input Terminal window on the bottom
right.
5. Type the command [USBMODE] in the field at the
bottom of the window (see Figure 65).