NavCom SF-3050 Rev.E - Manual (Page 119)

SF-3050 GNSS Product User Guide
– Rev E
3-93

To simplify this process, a profile can be
configured to begin and end data logging
to the USB flash drive.
4. Type the command
„[LOGFILE]start‟.
5. Click the Send button to start logging the
scheduled messages. Messages are logged in
.dat format to the USB flash drive.

If an error message appears, it may be related
to the compatibility of the USB flash drive.
Contact NavCom Customer Support:
http://www.navcomtech.com/Contact/Contact
Support.cfm

The logging commands are: [LOGFILE]start,
[LOGFILE]stop, [LOGFILE]pause,
[LOGFILE]resume, [LOGFILE]forcestart, and
[LOGFILE] (returns current logging status). After
power cycle, the file logging is in Stopped
status.

For detailed instructions on logging data to the
SF-3050 internal memory device via an Input
Terminal, see Appendix C of the Sapphire
Technical Reference Manual.

To avoid file system corruption on the
USB flash drive, always stop file logging
before removing the drive.
Direct Ethernet Connection via Static IP Address

The SF-3050 supports both UDP and
TCP connections. This section provides
only the basic configuration for a direct
Ethernet connection between the SF-
3050 and a PC. Refer to Chapter 2 of