NavCom SF-3050 Rev.E - Manual (Page 54)

SF-3050 Product User Guide
– Rev E
1-28
Figure 33: Set Navigation Modes/StarFire RTG ON
Refer to Figure 33 for the steps below:
68. Click the Retrieve Settings From the Receiver
button to retrieve the currently set navigation
modes from the receiver.
69. Select the ON radio button next to StarFire RTG if
StarFire is not enabled.
70. Click the Apply Changes to the Receiver button to
enable StarFire navigation. Then click Close.
71. Select StarFire License in the File Upload window
on the Receiver Options tab (see Figure 34).
Figure 34: StarFire License
72. Click .
73. Browse to NavCom\StarFire License on the PC.
The StarFire License file extension is *.lic.