NavCom SF-3050 Rev.E - Manual (Page 189)

SF-3050 GNSS Product User Guide
– Rev E
E-163
E ............................ Networked Transport of
RTCM Internet Protocol (NTRIP) Setup
Configure the SF-3050 for Wireless
Connection
Perform these steps:
1. Connect the SF-3050 to the computer either on
the USB port or the COM1 port.
2. Start StarUtil 3000 or another application that
provides an Input Terminal.
3. Configure the SF-3050 as a rover:
[RTKMODE]ROVER, RTCM, 1
4. Schedule the following messages:
[OUTPUT]PVT1B,ONTIME,1,USB1
[OUTPUT]ECHODGPSB,ONCHANGE,,USB1
[OUTPUT]RTKSTATUS1B,ONTIME,1,USB1
1. Configure the modem control parameters; for
example, assuming T-Mobile as service provider,
enter the following command on the Input
Terminal
[MODEMCONFIG] ‟‟‟‟,‟‟‟‟,”1, „IP‟,
„internet2.voicestream.com‟‟‟

For providers other than T-Mobile, the
APN „internet2.voicestream.com‟ should
be changed to the appropriate APN. If in
doubt, sometimes a blank APN works.